When the temperature drops below freezing, a frozen condensate pipe is one of the most common reasons our phones start ringing. Your boiler shuts down, the heating goes cold and a fault light starts flashing. The good news is that, in most cases, it’s a ten-minute job you can sort yourself with a kettle of warm water.
We’ve been servicing and repairing gas boilers across Glasgow, Lanarkshire, Renfrewshire and Ayrshire for over 30 years. This guide shows you how to spot a frozen condensate pipe, thaw it safely and stop it happening again. It also explains when it’s time to call one of our engineers.
If you smell gas at any point, stop. Leave the property and call the National Gas Emergency number on 0800 111 999.
What is a condensate pipe?
Every modern condensing boiler produces a small amount of slightly acidic water as it works. The condensate pipe carries that water away from the boiler to a drain. It’s usually a white or grey plastic pipe, around 22mm wide, that runs from the bottom of the boiler through an outside wall.
Because the water inside trickles slowly, the outside section of pipe can freeze solid in a cold snap. When it does, the water backs up into the boiler, and the boiler shuts itself down to protect itself.
Signs your condensate pipe is frozen
- Your boiler has stopped working during freezing weather
- A fault code or lockout light is showing on the display
- You hear a gurgling or bubbling noise from the boiler or the pipe
- The boiler tries to fire up, then cuts out again
If all of these happen on a frosty morning, a frozen condensate pipe is the most likely cause.
How to thaw a frozen condensate pipe safely
- Find the pipe. Follow the plastic pipe from the bottom of your boiler to where it leaves the house. The blockage is usually at the lowest point, a bend, or the open end where it meets the drain.
- Check you can reach it safely. If the frozen section is high up or above a drop, don’t climb a ladder in icy conditions. Call us instead.
- Pour warm water along the pipe. Use warm water from the kettle, not boiling. Pour it slowly along the frozen section. You can also hold a hot water bottle or microwavable heat pack against it.
- Keep going until it clears. You may hear the ice crack or water start to run into the drain. That’s a good sign.
- Reset your boiler. Press the reset button on your boiler (check your manual if you’re not sure where it is). It should fire up within a few minutes.
Never use boiling water, as it can crack the plastic pipe. Never use a blowtorch, heat gun or any naked flame.
What if the boiler still won’t start?
If your boiler still won’t fire after the pipe has thawed and you’ve reset it once, don’t keep pressing reset. Repeated resets can lock the boiler out completely. At that point, something else may be at fault, and it’s time to call a Gas Safe engineer. Our guide to why a boiler won’t fire up covers the other common causes.
How to stop your condensate pipe freezing again
If your condensate pipe freezes every winter, it’s worth getting it fixed properly. These are the permanent fixes our engineers carry out:
- Lagging the outside section with waterproof insulation
- Upsizing the external pipe to a wider diameter, which is much less likely to freeze
- Rerouting the pipe so more of it runs inside the house
- Fitting a trace heater, a small heating cable that keeps the pipe above freezing
We’ll look at how your pipe is run and recommend the simplest fix that works. As always, you’ll get a clear quote before any work starts.
Frozen condensate pipes across our area
We see frozen condensate pipes all over our patch every winter. They’re especially common in exposed and higher spots around East Kilbride and Strathaven, and out across Cumnock and Kilmarnock. From our main office in East Kilbride and our offices in Ayr and Kilmarnock, our directly employed engineers cover Glasgow, Lanarkshire, Renfrewshire and Ayrshire. Local pages: Kilmarnock, Cumnock and Strathaven.
When to call an engineer
Call us if:
- The pipe is high up or you can’t reach it safely
- Your boiler won’t restart after the pipe has thawed
- The pipe is cracked, split or leaking
- It keeps freezing every cold spell
- You’re not sure the condensate pipe is the problem
Winter boiler checklist
- Check your boiler pressure is between 1 and 1.5 bar when cold
- Bleed any radiators that are cold at the top
- Lag your condensate pipe before the first frost
- Make sure your annual boiler service is up to date
Need help with your boiler?
Our Gas Safe registered engineers are all directly employed, with no subcontractors, and there’s always someone to speak to 24/7. Whether you need a frozen pipe sorted or a permanent fix, we’ll get your heating back on.
Call our main office in East Kilbride on 01355 203 333, Ayr on 01292 833120 or Kilmarnock on 01563 594361. Or WhatsApp us on 07344081873. You can also book a repair online.
Frequently asked questions
Not usually. Your boiler is designed to shut down safely when the condensate pipe blocks. Once the pipe has thawed and the boiler has been reset, it should work normally. If it doesn’t, call an engineer.
The most reliable fixes are lagging, upsizing or rerouting the outside section of pipe. Our engineers can recommend the best option for your home.
A frozen condensate pipe is the most common cause of a boiler locking out in freezing weather. If thawing the pipe doesn’t fix it, there may be another fault.
Keeping your heating on a low, steady setting during a cold snap can help, as warm condensate keeps moving through the pipe. It isn’t a guarantee, so a permanent fix is better if it freezes every year.