If your boiler pressure drops below 1 bar, your boiler will usually lock out and stop heating your home. A one-off drop after bleeding radiators is normal. But if you’re topping up the pressure every few days or weeks, something is wrong.
We’ve been repairing gas boilers across Glasgow, Lanarkshire, Renfrewshire and Ayrshire for over 30 years, and pressure loss is one of the most common faults we fix. Here’s how to top up your pressure safely, what usually causes it to drop, and when to book a repair.
What should my boiler pressure be?
When your heating is cold, the pressure gauge should read between 1 and 1.5 bar. It will rise a little when the heating is running. Below 1 bar is too low. Below 0.5 bar, most boilers stop working altogether.
How to repressurise your boiler
Most combi boilers have a filling loop, a short hose or a built-in key with two valves, underneath the boiler. Always check your boiler’s manual first, as every model is slightly different. The general steps are:
- Turn the boiler off and let the system cool down.
- Find the filling loop under the boiler and make sure both ends are connected.
- Open the valves slowly, one then the other. You’ll hear water flowing into the system.
- Watch the pressure gauge. Close both valves when it reaches 1 to 1.5 bar.
- Turn the boiler back on and reset it if needed.
Don’t overfill it. If you go too far, you’ll need to bring the pressure down again.
Why does my boiler keep losing pressure?
A leak somewhere in the system
The most common cause is a small leak, often somewhere you can’t see. It may be under the floorboards, behind a radiator, or at a radiator valve.
A dripping pressure relief valve
If the pressure relief valve isn’t sealing properly, it lets water out through the copper pipe outside your home. Check that pipe for drips or damp marks on the wall beneath it.
A failed expansion vessel
When the expansion vessel loses its charge, the pressure swings up when the heating runs. Water then escapes through the relief valve and the pressure drops when the system cools. This up-and-down pattern is a classic sign.
Recently bled radiators
Bleeding radiators lets air and some water out of the system, so a small drop afterwards is normal. Top up once and it should hold. Our guide to bleeding radiators explains how.
An internal boiler leak
Sometimes the leak is inside the boiler itself, from a worn seal or a corroded part. You may see water under the boiler. Read boiler leaking water for what to do.
How to spot a hidden leak
- Damp patches or stains on ceilings, walls or floors
- Water marks or rust under radiators and around valves
- Drips from the copper pressure relief pipe outside
- Damp or tide marks on the wall below that pipe
- Floorboards that feel soft or look discoloured
How we find and fix pressure loss
Our Gas Safe engineers will check the whole system to find out where the pressure is going. That usually means testing the expansion vessel and recharging it if needed, checking the pressure relief valve, and looking for leaks at the boiler, radiators and pipework. Once we know the cause, you’ll get a clear quote before any parts are fitted. If a part needs ordering, we arrange the return visit for you.
Pressure loss repairs near you
Our directly employed engineers fix pressure problems every week from our main office in East Kilbride and our offices in Ayr and Kilmarnock. That includes Rutherglen, Cumnock and Maybole, and right across the areas we cover.
When to call an engineer
- You’re topping up the pressure more than once every few months
- The pressure drops overnight or within a few days
- The copper pipe outside is dripping
- You can see water under the boiler or a radiator
- The pressure rises and falls a lot as the heating goes on and off
If you smell gas, leave the property and call the National Gas Emergency number on 0800 111 999.
Get your boiler pressure fixed
Our Gas Safe engineers are all directly employed, with no subcontractors, and there’s someone to speak to 24/7, 365 days a year.
Call our main office in East Kilbride on 01355 203 333, Ayr on 01292 833120 or Kilmarnock on 01563 594361. Or WhatsApp us on 07344081873. You can also book a repair online.
Frequently asked questions
Ideally, hardly ever. Once or twice a year, perhaps after bleeding radiators, is normal. If you’re doing it every few weeks, there’s a fault.
Low pressure isn’t dangerous in itself, but your boiler won’t work properly and may lock out. Top it up, and call us if it keeps dropping.
Running repeatedly on low pressure can strain the pump and other parts. The cause, such as a leak, can also damage your home if it’s left.
A steady overnight drop usually means a leak somewhere in the system or a relief valve that isn’t sealing. It needs an engineer to find it.